On this page

Troubleshooting

A plug-in is not working

Find out why a plug-in from the collection has stopped or will not start, from what its tab in Starboard says. Each plug-in also has its own Problems page, with the messages only it shows.

Find your answer
Flow chart: A plug-in is not working. The same chart is written out in words after it.Needs setting upDid not start or FailedNot supportedActive, but a card iswrongYesNoA plug-in is notworkingOpen its tabSettings, thenPlug-ins, then itsnameWhat does itsstate say?Did it stop soonafter an update?Finish setting it up1Start it again2Update it or updateStarboard3Roll it back4A card says No answerAnother article
The chart in words

Start: A plug-in is not working

1 Finish setting it up

A setting it needs is empty, or it has never been set up.

  1. On its tab, select Finish setting up. The first setting it needs has the focus.
  2. Fill it in and save.
  3. Select Activate.

2 Start it again

  1. Read the message under its state: it says why it stopped.
  2. Select Try again.
  3. If it stops again, go to System, then Logs, and find its name.
  4. Read the plug-in's own Problems page, such as Direct play's.

3 Update it or update Starboard

Your Starboard's plug-in API is outside what this version works with, so Starboard stopped it.

  1. Select Check for an update on its tab.
  2. If there is none, update Starboard. Every plug-in here needs plug-in API 1.14, in Starboard 0.18.0 or later, and Library clean-up needs plug-in API 1.15, in Starboard 0.19.0 or later.

4 Roll it back

  1. On its tab, in Versions, select Roll back to and the version you had.
  2. Enter your Starboard password and select Roll back.
  3. Tell its maker what happened, at the plug-ins' issues on GitHub.

Find out more

This page on GitHub, where the help is written.