Disk forecast: Install
Add Disk forecast from Starboard's Catalogue, where it is listed under System. Starboard shows what it may do and tests it before anything is added. At the end, Disk forecast is active and its card is ready for your dashboard.
Before you begin
- Starboard with plug-in API 1.14 or later. An older Starboard is offered an earlier version: read Updates.
- Your Starboard password. Adding and removing a plug-in ask for it.
What it may do
Starboard lists these before you add it, each with its risk.
| Permission | Risk |
|---|---|
Processor, memory and disks (system:read) |
Low |
What it runs:
- main: reaches only Starboard, on its own network: it cannot reach your home network or the internet. It can use its own folder in Starboard's data (
data/plugins/disk-forecast).
Like every plug-in, it runs read only, as a user that is not root, with no extra rights. Its image is pinned by digest, so what you approved is what runs.
Memory and processor
- main: 48 MB of memory and 0.1 of a processor core at most.
These figures are the most it may use.
Add it
- Go to Settings, then Plug-ins, then Catalogue.
- Under System, find Disk forecast and select Install….
- A slide-out opens with what it can read, change and reach. Read it all.
- Enter your Starboard password and select Install Disk forecast. To stop, select Cancel: nothing is installed.
- Disk forecast's own tab opens under Settings, then Plug-ins. Select Activate. Its state changes to Active.
- Add its card to your dashboard. Read Dashboard card.
There is nothing else to set up: it has no settings of its own. Its card says Measuring at first, and the first forecast comes the day after you activate it.
Tip: Disk forecast is marked Recommended in the catalogue.
Add it by its address
On the Catalogue page, under Add one from elsewhere, paste this into The plug-in's manifest address, then select What it does and carry on from step 3:
https://raw.githubusercontent.com/TheMightyTRex/starboard-plugins/main/disk-forecast/starboard-plugin.json
Or run its installer, install.py in its folder, on any computer with Python, and give your Starboard's address.
Remove it
- Go to Settings, then Plug-ins, then Disk forecast.
- Under Remove, select Remove Disk forecast.
- Choose where its folder goes: Keep it with Starboard's data (in
data/plugins/.removed) or Move it to the holding folder, listed in System, Clean up, where you can put it back or delete it for good. - Enter your Starboard password and select Remove.
Its containers stop and go, and its API key stops working. Nothing is deleted.
To stop it for a while instead, select Deactivate on its tab: its settings and folder are kept.
Find out more
This page on GitHub, where the help is written.