On this page
Maintainerr: Problems
Find what is wrong with Maintainerr, then follow the numbered answer.
The chart in words
Start: Maintainerr is not working as it should
- Then: What does its tab say?
- Did not start: 1. Start it again
- Not supported: 2. Update it or update Starboard
- Active, but something is wrong: What is wrong?
- Its page does not open: 3. Open its page
- It cannot reach Jellyfin or Seerr: 4. Give it its keys
- A rule removes nothing: 5. Give the rule an action
1 Start it again
Its tab says Did not start when Maintainerr did not start, or stopped answering.
- On Maintainerr's tab, read the message under its state: it says why it stopped.
- Select Try again.
- If it stopped soon after an update, select Roll back to and the version you had. Read Updates.
- Still failing: go to System, then Logs, and find its name.
2 Update it or update Starboard
Your Starboard's plug-in API is outside what this version of Maintainerr works with, so Starboard stopped it.
- Select Check for an update on its tab.
- If there is none, update Starboard. Read Update Starboard.
3 Open its page
Maintainerr's page is on your home network, at this computer's address and the port Starboard chose for it. The port is not always the usual one: Starboard takes the next free port when that one is in use.
- Check Maintainerr's tab says Active. Starboard gives it a port only once it is active.
- Under Its web page, read the address, then select Open Maintainerr.
- Open it from a device on your home network. It does not open from away from home.
- If it still does not open, deactivate it, activate it again and wait a minute for the app to start.
4 Give it its keys
Starboard gives Maintainerr no key, so it reaches Jellyfin and Seerr only with keys you make.
- In Jellyfin, go to Dashboard, then API keys, and make a key for Maintainerr.
- In Maintainerr, add Jellyfin with that key. Jellyfin is on this computer, at
http://host.docker.internal:8096. - If you use Seerr, make a key in Seerr's own settings and add it in Maintainerr too.
5 Give the rule an action
A rule only lists what it finds until you give it an action. That is on purpose, so nothing goes by mistake.
- In Maintainerr, open the rule and check what it finds.
- When you are sure, give it an action that removes.
- Check Maintainerr has its keys for Jellyfin, and for Seerr if the action goes through Seerr.
Report a problem
If none of these helps, tell its maker, with what its tab says: the plug-ins' issues on GitHub.
Find out more
This page on GitHub, where the help is written.