Home Assistant

Version 1.1.3 · plug-in API >=1.14 <2.0

PublishedHow to add it
On this page

Home Assistant: Problems

Find what is wrong with the Home Assistant plug-in from what its tab or its card says, then follow the numbered answer.

Find your answer
Flow chart: The Home card is not working as it should. The same chart is written out in words after it.Failed or Not answeringNot supportedActive, but the card iswrongNeeds setting upNo answer from HomeAssistantWarning when all is wellThe Home card is notworking as it shouldWhat does its tab say?What does the cardsay?Start it again1Update it or updateStarboard2Finish setting it up3Check the address, tokenand ids4Change the warning states5
The chart in words

Start: The Home card is not working as it should

1 Start it again

  1. On the plug-in's tab, read the message under its state: it says why it stopped.
  2. Select Try again.
  3. If it stopped soon after an update, select Roll back to and the version you had. Read Updates.
  4. Still failing: go to System, then Logs, and find its name.

2 Update it or update Starboard

Your Starboard's plug-in API is outside what this version of the Home Assistant plug-in works with, so Starboard stopped it.

  1. Select Check for an update on its tab.
  2. If there is none, update Starboard. Read Update Starboard.

3 Finish setting it up

The card says "Add the address, a token and what to show in the plug-in's settings". It needs all three.

  1. Go to Settings, then Plug-ins, then Home Assistant.
  2. Fill in Home Assistant's address, Long-lived access token and What to show. Read Install for where to make the token.
  3. Select Save.

4 Check the address, token and ids

The plug-in asked Home Assistant and got no usable answer, or did not answer Starboard within 3 seconds.

  1. Open Home Assistant's address in your browser, and check Home Assistant opens.
  2. Check each id in What to show is exactly as Home Assistant shows it. One wrong id stops the whole card.
  3. If the token was deleted in Home Assistant, make a new one and paste it in Long-lived access token. A saved token is never shown, so pasting it again is the only way to be sure.
  4. If Home Assistant is slow to answer, show fewer things: it asks for each one in turn, and Starboard waits only 3 seconds for the card.
  5. Select Save, then wait a minute for the card to ask again.

5 Change the warning states

The card says Warning when any thing is in a state from Warn when any is, on, open, unlocked by default. A light that is on counts too.

  1. Go to Settings, then Plug-ins, then Home Assistant.
  2. In Warn when any is, keep only the states that should warn you, separated by commas.
  3. Select Save.

Or take the things you do not need warnings for out of What to show.

Report a problem

If none of these helps, tell its maker, with what its tab and the card say: the plug-ins' issues on GitHub.

Find out more

This page on GitHub, where the help is written.