On this page
Outside services: Problems
Find what is wrong with Outside services from what its tab or its cards say, then follow the numbered answer.
The chart in words
Start: Outside services is not working as it should
- Then: What does its tab say?
- Failed or Not answering: 1. Start it again
- Not supported: 2. Update it or update Starboard
- Active, but a card is wrong: What does the card say?
- Add addresses in the settings: 3. Add the addresses
- Not checked yet: 4. Wait for the first check
- Not answering and a name: 5. Check what is not answering
- Checks at the old interval: 6. Start it again after a change
1 Start it again
- On Outside services' tab, read the message under its state: it says why it stopped.
- Select Try again.
- If it stopped soon after an update, select Roll back to and the version you had. Read Updates.
- Still failing: go to System, then Logs, and find its name.
2 Update it or update Starboard
Your Starboard's plug-in API is outside what this version of Outside services works with, so Starboard stopped it.
- Select Check for an update on its tab.
- If there is none, update Starboard. Read Update Starboard.
3 Add the addresses
The card says "Add addresses in the plug-in's settings" and Needs setting up: there is nothing to check yet.
- Go to Settings, then Plug-ins, then Outside services.
- In Addresses to check, enter each address, such as
Router http://192.0.2.1. - Select Save.
4 Wait for the first check
The card says "Not checked yet" and Waiting. The first check starts a few seconds after Outside services starts, and each address can take up to 8 seconds, so wait a minute or two. After that, it checks at Check every.
5 Check what is not answering
The card says "Not answering" and the names, such as "Not answering: NAS". At the last check, those addresses gave no answer within 8 seconds, or answered with a server error.
- Open the address from the list card in your browser.
- If it does not open there either, check the device is on and on your network.
- If it opens in your browser, check the address in Addresses to check is exactly the same, including
http://orhttps://and any port. - Wait for the next check: the card changes by itself.
6 Start it again after a change
A new Check every is used only when Outside services starts.
- Go to Settings, then Plug-ins, then Outside services.
- Select Deactivate.
- Select Activate.
Report a problem
If none of these helps, tell its maker, with what its tab and the cards say: the plug-ins' issues on GitHub.
Find out more
This page on GitHub, where the help is written.